Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

IASTALL THE DICEqC 1.2 MOTORIZED H-H MOUNT--------------------

Super Moderator
Joined
Oct 22, 2007
Messages
3,205
IASTALL THE DICEqC 1.2 MOTORIZED H-H MOUNT--------------------

-----------------------------------------------Page 1-----------------------------------------

1-1) Find an appropriate for installation first.

1-2) Make sure there is no obstacle in the sout sky such as tree or toll biilding.

1-3) Make sure the mounting pole is exactly leveld in vertical.

1-4) Fix the h-h motor on the mounting pole and attach the antenna dish on to the motor pole.

1-5) Make sure the center of the antenna dish is with the center of the motor well.

1-6) Make motor elevation at 52*.

1-7) make antenna dish scale 38* aproximately.

1-8) Tide all bolds and nuts. (not very tide)

1-9) Make koaxial RG6 cable connection . (see manual book)

1-10) Draw the koaxial RG6 cable as close as possible to the mounting pole to prevent from any
interference between antenna dish bracket and koaxial cable.

1-11) Rotate the motor all together with the antenna dish tru south by hand.

---------------------------------------------------o-------------------------------------------

MAKE SETTINGS

-------------------------------------------------pAGE 2----------------------------------------

2-1) Switch on your digital box receiver.
2-2) Put on hotbird 13*E channel. (RAI1,2,3)

Note: Thes is HUMAX settings other receivers are similar, manual settings apply for all.

2-3) (1) press menu (2) installation (3) service searching (4) antenna settings
(5) antenna alternative (6) antenna alternative (7) make DISEqC command mode user.

2-4) press west button for four times(4 seconds in between)
press exit end ok to store changed settings press menu to exit .

2-5) (1) press menu (2) installation (3) status (4) signal quality.

2-6) By hand rotate the motor all together with antenna dish to find the signal from west to east
slowly slowly and get the bast signal quality.

2-7) Tide the motor braket very well.

2-8) Now tilt the antenna dish up and down and get the highest signal quality.

2-9) Tide the antenna dish braket very well.

2-10) Now motor is all raddy set

---------------------------------------------------o----------------------------------------------

SETTINGS WITH OTHER SAT

-------------------------------------------------Page 3--------------------------------------------

3-1) put on astra 19.2*E channel taquilla or other.

3-2) (1) Press menu (2) installation (3) service searching (4) antenna settings
(5) antenna alternative (6) antenna alternative (7) make DISEqC command mode installer.

3-3) On movement press east or west by pressing left or right from your remote.

3-4) When you see the signal stop rotate immediately by press up or down left or right.

3-5) Chang DISEqC command from installer to user, puls back slowly slowly
until get the best signal press exit and ok to stor changes.

----------------------------------------------------o-----------------------------------------------
3-6) To set another sat all you have to do is the same like page 3 the different is the sat
for example eutelsat w2 16*E.
----------------------------------------------------o-----------------------------------------------

NOTE: YOU CAN ALMOST DRIVE THE MOTOR EAST/WEST VIA MANUAL BUTON ON THE BOTTOM OF THE MOTOR
(SEE MANUAL BOOK)
 
New member
Joined
Sep 14, 2009
Messages
48
great post because before we only know about 1.0 and 1.1 diseq setting so that post essential for new users
 
Banned
Joined
Sep 18, 2010
Messages
0
  • Deleted by N/A
Show…
Top